UBIQUIT UniFi G3 Reader, prieigos kontrolės skaitytuvas

Compact third-generation access reader with Apple Touch Pass support.
Unlock with an NFC card, UniFi Identity mobile app, or Touch Pass
Supports hand-wave unlocking as a request-to-exit device
Provides entry and exit greeting messages
IP55-rated weather resistance (-30 to 45°C)
Connects to UniFi Access Hub via PoE

Dimensions    93 x 40 x 36.5 mm (3.7 x 1.6 x 1.4")
Weight    82 g (2.9 oz)
Enclosure material    Polycarbonate, glass
Mounting material    Aluminum alloy
Mounting    In wall, gang box
Weatherproofing    IP55
Networking interface    (1) 10/100 MbE RJ45 port
Connectivity    BLE 4.1
NFC
Power method    PoE
UL 294 Power-limited Class 2 PSU
UL 60950-1/62368-1 LPS/PS2 PSU
Supported voltage range    48V DC
Max. power consumption    5W
ESD/EMP protection    Air: ±15kV, contact: ±8kV
Sensors    Proximity sensor
Speaker    (1) 8 ohm, 0.7W
LEDs    R/G/B/W (Learn more)
Button    (1) Factory-reset
NFC frequency    13.56 MHz
NFC read range    < 30 mm
NFC technology    ISO/IEC 14443A / 14443B / 15693 / 18092 (Ecma 340)
MIFARE Classic / MIFARE DESFIRE
Sony FeliCa™ (ID only)
NFC Forum tags T1T, T2T, T3T, T4T and T5T
ECP 2.0
Operating environment    Outdoor use
Ambient operating temperature    -30 to 45° C (-22 to 113° F)
Ambient operating humidity    5 to 90% noncondensing
Software information    The software version of a product can be checked at https://unifi.ui.com
UL 294 level    Destructive attack: Level I
Line security: Level I
Endurance: Level I
Standby power: Level I
UL 294 statement    Compliance with IEEE 802.3 specifications was not verified as part of UL 294.
The equipment is intended to comply with the section of the National Electrical Code, ANSI/NFPA 70, Article 725.121, Power Sources for Class 2 and Class 3 Circuits.
PoE cabling requirements    Cable 5e cabling is the minimum performance category recommended. The performance category utilized should match the transmission speed required at the installation site.
The minimal conductor gauge permitted to connect between the PSE or power injector and the PD shall be 26 AWG (0.13 mm 2 ) for patch cords; 24 AWG (0.21 mm 2 ) for horizontal or riser cable.
CAN/ULC-60839-11-1 Grade    Grade assignment: I
Certifications    CE, FCC, IC, UL 294, CAN/ULC-60839-11-1
Document number, and issue date and/or revision level    UA-G3, V01
Management application    UniFi Access: Version 3.0.15 and later